网站首页话放/话筒放大器

DBX 676 话放通道条/均衡器/压缩器

发布时间:2016-04-27编辑:DanceSmile阅读(

    专业的血统

    在DBX的产品线中,我们很自豪的为大家介绍这款全新的676 电子管话放通道条。676各方面都是最好的,它代表着DBX在动态处理器方面长达40多年的成就。

    DBX 676提供了纯正的高电压A类电子管话放模块,它可以运行250V电压,所以你可以将你的信号变的极其清澈和极其浑浊,只要你需要它。676同时集成了压限器,是基于备受追捧的dbx162SL而设计,同时带3段均衡,可以消除中频。

    676 这款完美的通道条,无论是录音还是现场使用,都将带给你专业的音质,正如它一流的制作和复古风格的控制,VU表和艺术级的数字输出卡一样出色。

     

    DBX 676主要特点:

    • A类电子管话放,高压增益

    • 高清晰度复古的VU表

    • 压缩器是基于dbx162SL设计

    • 3段半参量均衡

    • 1/4” 和卡侬输入输出接口

    • 前面板带乐器输入接口

    • 侧链插入

    DBX 676技术参数:

    Mic Preamp Connector

    Female XLR Pin 2 Hot; Electronically balanced/unbalanced

    Mic Preamp Input Impedance

    1.9 kΩ

    CMRR

    >85 dB from 20 Hz to 3 kHz, >70 dB from 3 kHz to 20 kHz

    Instrument Input Connector

    Tip-Sleeve ¼” Jack

    Input Type

    (instrument) Unbalanced

    Instrument Input Impedance

    500 k Ω

    Max Input

    (instrument) +21dBu unbalanced

    Preamp Insert Connector

    Tip-Ring-Sleeve ¼”, RF filtered

    Preamp Insert Type

    Unbalanced, Tip = send, Ring = return

    Line Outputs (Preamp & Compressor/Limiter) Connector

    Male XLR and Tip-Ring-Sleeve ¼” (Pin 2 and Tip hot)

    Line Outputs (Preamp & Compressor/Limiter) Type

    Servo-balanced/unbalanced

    Line Outputs (Preamp & Compressor/Limiter) Impedance

    Balanced 30 Ω, unbalanced 15 Ω

    Line Outputs (Preamp & Compressor/Limiter) Maximum Output Level

    > +21 dBm (into a 600 ohm load)

    Compressor Sidechain Insert Connector

    Tip-Ring-Sleeve ¼”, RF filtered

    Compressor Sidechain Insert Type

    Unbalanced, Ring = output, Tip = input

    Compressor Sidechain Insert Impedance

    1 kΩ (output), 50 kΩ (input)

    Vacuum Tube Type

    12AU7A / ECC82

    Vacuum Tube Grid Power Supply

    +250V DC

    Vacuum Tube Heater Power Supply

    +12V DC

    Frequency Response (Mic Input)

    20 Hz to 50 kHz, +0/-1dB, 40 dB gain

    Frequency Response (Instrument Input)

    30 Hz to 70 kHz, +0/-1dB, unity gain

    THD + Noise (Mic In to LIne Out)

    0.25% typical at 0 dBu out, 1 kHz, 40 dB gain

    THD + Noise (Instrument In to Line Out)

    0.2% typical at 0 dBu out, 1kHz, unity gain

    Equivalent Noise Level

    Typically > -123 dBu with a 150 Ω source load, 22 Hz to 22 kHz

    Noise Floor

    Mic Insert to Comp Output: <-93 dBu, unity gain, EQ flat and no gain reduction

    Preamp Function Switches/Controls: Instrument Input

    Selects between microphone XLR input and front panel ¼” instrument input

    Preamp Function Switches/Controls: +48V

    Sends +48 VDC through 6.81 kΩ resistors to pins 2 and 3 of the microphone input

    Preamp Function Switches/Controls: 20dB Pad

    Attenuates the microphone input by 20 dB

    Preamp Function Switches/Controls: Polarity Invert

    Reverses pins 2 and 3 of the microphone input XLR

    Preamp Function Switches/Controls: 80 Hz Low Cut

    Enables an 80 Hz, 12 dB/octave high pass filter in the microphone and instrument signal path

    Preamp Function Switches/Controls: Gain Control Range

    -∞ to +55 dB for Microphone Input; -∞ to +40 dB for Instrument Input

    Preamp Function Switches/Controls: Post Tube Attenuation

    -∞ to 0 dB

    Preamp Function Switches/Controls: Peak Indicator

    Illuminates RED when the Preamp is within 3 dB of clipping

    EQ Low Frequency

    100 Hz, Low-pass shelving filter

    EQ High Frequency

    10 kHz, High-pass shelving filter

    EQ Mid Frequency

    Sweepable from 100 Hz to 8 kHz

    EQ Function Switches/Controls: Narrow

    Selects the “Q” of the MID Frequency EQ. “OUT” position Q = 0.9; “IN” position Q = 2.9

    EQ Gain

    (All Bands) Sweepable from –15 to +15 dB

    Compressor Threshold Range

    -40 dBu to +20 dBu

    Compressor Threshold Characteristic

    Selectable OverEasy™ or Hard Knee

    Compressor Ratio

    Variable 1:1 to ∞:1; 60 dB maximum Compression

    Compressor Attack/Release Modes

    Selectable Manual or Auto

    Compressor Manual Attack Time

    Scalable program-dependent; Typically 400 dB/msec to 1 dB/msec

    Compressor Manual Release Time

    Scalable program-dependent; Typically 4000 dB/sec to 10 dB/sec

    Compressor Auto Attack Time

    Program-dependent, typically 15 ms for 10 dB, 5 ms for 20 dB, 3 ms for 30 dB

    Compressor Auto Release Time

    Program-dependent, typically 120 dB/sec

    Compressor Output Level Control Range

    -20 dB to +20 dB

    Compressor Peak Indicator

    Illuminates RED when the Compressor/Limiter is within 3 dB of clipping

    Limiter Type

    dbx PeakPlus™

    Limiter Threshold Range

    -4 dBu to + 22 dBu (off)

    Limiter Ratio

    ∞:1

    Limiter Attack and Release

    Program-dependent

    Power Supply

    Universal switch-mode

    Operating Voltage

    100 – 240 VAC, 50/60 Hz

    Power Requirements

    20 Watts

    Fuse

    T2.5AL 250V